Rail Mount Stainless Steel Fender Holder Dual - 9.5"The Rail Mount Dual Fender Holder is for use on 7/8" or 1" tubing. Easy to mount, these fender holders adjust to any angle of railing and can hold any style fender. Folds flat for easy storage when not...

Rail Mount Stainless Steel Fender Holder Dual - 7.5"The Rail Mount Dual Fender Holder is for use on 7/8" or 1" tubing. Easy to mount, these fender holders adjust to any angle of railing and can hold any style fender. Folds flat for easy storage when not...

Stainless Steel Chain Gripper PlateThis Chain Gripper Plate stabilizes anchor chains and reduces stress on windlass when anchored in heavy seas. The two holes are used for a bridle application with two Bow Shackles (147212) to connect lines to port and...

Chrome Brass Hinged Chain Deck PipeThis Hinged Chain Deck Pipe facilitates the storage of anchor lines out of the way below deck, reducing the risk of trip hazards on deck. The circular pipe features a hinged cap for easy access. Chain can remain in...

Stainless Steel Chain Stopper - 5/16" - 3/8"Chain Stoppers help prevent damage to the windlass and reduce the risk of accidental free fall of the anchor while under way. Chain Stoppers mount alone or inside most bow rollers and work with your anchor...

Spreader Flag Halyard KitIncludes 40ft. of polyester line, block with bail and shroud cleat.

Pulpit Anchor for 1" RailThis fitting can be used on the stern rail and bow pulpit to terminate jaw fittings for lower or upper life lines. (1/2" hole). The hole will not accept cast gate hooks. 

Eye to Deck Toggle FittingThis fitting can be mounted to any flat surface and accept life line fittings, line, etc. Toggling action is 140 degrees. 

Eye to Jaw FittingThis fitting will convert a small bail at the stern rail to the standard gate eye to accept the over center gate hook.

Eye to Eye Adjustable FittingThis fitting can be used wherever an eye is required on each side of the stanchion. Adjustable between 3/4" and 1". 

Short Adjuster for 3/16" WireGenerally used at the stern rail in conjunction with the single gate eye to tension that section of the gate.Specifications:3/16" Wire1/4" Pin1" adj.

Short Adjuster for 1/8" WireGenerally used at the stern rail in conjunction with the single gate eye to tension that section of the gate.Specifications:1/8" Wire1/4" Pin1" adj.